The remarks, given in a former place, relating to tools for turning, apply to those for planing as well, except that in planing tools greater rigidity and strength are required.The intricacy of the subject renders it a difficult one to deal with except by the aid of diagrams, and as such mechanism may be inspected in almost any machine fitting shop, attention is called to the subject as one of the best that can be chosen for demonstration by diagrams. Problems of these variable speed movements are not only of great interest, but have a practical importance not found in many better known problems which take up time uselessly and have no application in a practical way.
Director
Cores are employed mainly for what may be termed the displacement of metal in moulds. There is no clear line of distinction between cores and moulds, as founding is now conducted; cores may be of green sand, and made to surround the exterior of a piece, as well as to make perforations or to form recesses within it. The term 'core,' in its technical sense, means dried moulds, as distinguished from green sand. Wheels or other castings are said to be cast in cores when the moulds are made in pieces and dried. Supporting and venting cores, and their expansion, are conditions to which especial attention [95] is called. When a core is surrounded with hot metal, it gives off, because of moisture and the burning of the 'wash,' a large amount of gas which must have free means of escape. In the arrangement of cores, therefore, attention must be had to some means of venting, which is generally attained by allowing them to project through the sides of the mould and communicate with the air outside.58