ここから本文です
TWO:The constable gave way to panic. He temporised with his duty. "Stow it," he begged, "I can't take you to the station like this. They'll never believe me." He took off his hat and rubbed his tingling forehead.[Pg 93] "Say it's a dream, mate," he added, in a whining voice. "'Ow can I go 'ome to the missus with a tale like this. She'll say it's the gin again. It's always my luck to strike something like this. When the ghost came to Bapchurch churchyard, it was me wot saw it first, and nobody believed me. You go along quietly, and we'll look over it this time." "I must not fail to tell you of a remarkable temple that we have seen; not that any are unworthy of mention, but this one is certainly very curious. It is known as the Temple of Rengenhoin, and contains one thousand idols of large size; then each idol in this lot is surrounded by several smaller ones, and there is one idol larger than all the rest. The[Pg 297] whole number is said to be 33,333. We did not count them to make sure that the estimate was correct, but I should think that there must be thirty thousand at least, so that a few odd thousands, more or less, would make no difference. The whole of the inside of the temple is full of them, and each figure is said to have a particular fable connected with it. The temple is nearly four hundred feet long, and is certainly a very fine building; and there is an artificial pond in front of it, which is covered with aquatic flowers in the season for them. There is a veranda that was used in olden times for a shooting-gallery for archery purposes; it is more than two hundred feet long, and there are records of some famous matches that have been shot there. The best on the books took place more than six hundred years ago, when one man is said to have hit the bull's-eye of the target 8,000 times out of 10,000, and another is reported to have done the same thing 8,133 times in 13,053. That was certainly good shooting, and I don't believe that it would be easy to find a bowman to-day who could equal it.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:In preparing illustrations for this volume the publishers have kindly allowed me to make use of some engravings that have already appeared in[Pg 10] their publications relative to China and Japan. I have made selections from the volumes of Sir Rutherford Alcock and the Rev. Justus Doolittle, and also from the excellent work of Professor Griffis, "The Mikado's Empire." In the episode of a whaling voyage I have been under obligations to the graphic narrative of Mr. Davis entitled "Nimrod of the Sea," not only for illustrations, but for incidents of the chase of the monsters of the deep.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:Perhaps you cant, he said, and youd better have your nap. That wont be waste of time. Youre tired with talking, and Im sure I am too.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:I cant say whether I should have been pleased or not, she said. It didnt happen. But Im sure I dont know why you sent your typewriter in here to talk to me. I dont know what you think I should find to say to her. With Alice here too.The sergeant's low order broke the platoon into column by file, Quinn rode toward its head with his blade drawn, and as he passed me he handed me his glass. "Here, you with no carbine, stay and watch that boat till I send for you. If there's firing, look sharp to see if any one there is hit, and who, and how hard. Watch the boat, nothing else."

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:He broke off and struggled with some queer kind of mechanical emotion. "And now they play games with us. They wind us up and make us do all sorts of things, just for fun. They try all sorts of experiments with us, and we can't help ourselves because we're in their power; and if they like they can stop the clock, and then we aren't anything at all."
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.